What are some home methods for cutting wine bottles

People should have some wine bottles left over from dinner parties at home, and many people will choose to discard these wine bottles. In fact, these leftover wine bottles can be used to make many daily necessities, such as containers for vases and some other items, but many people don’t know how to make these things, or even how to cut wine bottles. So, what are some home methods for cutting wine bottles?

First, what are the home methods for cutting wine bottles? First, put a rubber band on the place where you want to cut, and then use a marker to draw a line along the place where the rubber band is put. The reason we put on the rubber here is to draw the appropriate cutting position. After we draw the lines, we can remove the rubber band and check if there are any poorly drawn areas and make modifications. Then we can start cutting. We just cut back and forth slowly along the line we just drew. Don't use too much force when cutting, and be careful not to cut through in one place. The main thing is to cut a groove on all four sides first, and then repeat this step.

Secondly, because we did not cut through every surface during cutting, the cut part is not neat. Therefore, we only need to grind the burrs with a grinder after cutting, or grind it again with fine sandpaper. Our cutting work is completed. If the reason you cut is to make a vase, then we will definitely need to water the flowers when planting them, so we need to make a bottom hole. When drilling the base hole, be careful not to be too hasty or too fast. It is best to add water, use force carefully, and drill slowly.

What are some home methods for cutting wine bottles? Finally, our drilling work is completed, and we can start planting flowers with peace of mind. We don’t have to worry about suffocating them by watering them too much. Cutting work is risky, especially for novices, so you must be extra careful and pay attention to the strength to avoid getting cut. Drink it and keep the bottle. Soak the bottle in water for about an hour and the label can be easily torn off. Then find a piece of rope and tie it to the place where you want to cut (if you want the cut to be smooth, the rope must be tied flat). Use a straw (if you don't have a straw, use chopsticks) to drop flammable material (the liquid in the brown box next to it) on the rope. Flammable material can be gasoline, alcohol, turpentine, lubricating oil, etc. If you really don't have any, use salad oil, or buy a candle and coat it with wax. The flammable material on the rope must be flammable enough to ensure that a circle of rope is ignited at the same time so that the whole circle is heated evenly; do not let other parts of the bottle get stained with flammable liquids to prevent multiple places from being heated and uneven cuts. After the fire is extinguished or the rope is burned out, immediately immerse the bottle in cold water. Then there will be two results. If the combustion is not complete, there will be a circle of cracks. Find a piece of soft cloth to hold it, and knock it on the corner of the table, and the bottom will fall off. If it burns fully, the bottom will fall off once it enters cold water. Polishing. Use sandpaper to smooth the cut to avoid cutting your hands. If you don’t have sandpaper, buy a tube of 502 glue (or glass glue), apply it on the cut in a circle, and it will form a protective layer after it dries.