How to install a zipper pull? Introducing detailed steps!

In daily life, we often encounter situations where zippers are broken. For example, the zipper on a pair of pants is accidentally broken, but the pants are still in good condition. At this time, the zipper needs to be replaced. Or if only the zipper head is broken, the easiest way is to replace the zipper head. This solution has the lowest cost, but there must be many people who don’t know how to install the zipper head, so the following will teach you the detailed steps.

How to change the zipper puller?

Step 1:

These are the tools and materials needed.

Step 2:

Use a lighter to flick the edge of the zipper head first ~ so that it won’t come off in the following steps ~ (failed this time...)

Step 3:

As the front side ~ the left side? ? The teeth on the right side should be higher than the teeth on the left side.

Step 4:

Install the zipper head and press it down hard.

Step 5:

Then pull both sides of the zipper ~ the slider will slide down naturally ~

Step 6:

Just put it on ~ But this step requires a lot of patience. It took more than ten minutes to tear the texture of the edge apart (; ￣ェ￣)

Step 7:

I really like this step. Use needle-nosed pliers to pull off about 4 pairs of teeth. I personally think it is easier to pull outward and upward.

Step 8:

You can also pull off the teeth according to your own needs.

Step 9:

Use needle-nosed pliers to clamp the U-code and install it on the top of the first tooth. Clamp it tightly.

Step 10:

Right side same as left side

Step 11:

Next, install the rear parts.

Step 12:

First, pull off a few pairs of teeth.

Step 13:

Step 14:

Install the I-code

Step 15:

The last step is to install the pull tab on the zipper head.

Step 16:

After installing the pull tab into the buckle on the zipper head, use needle-nosed pliers to clamp the open buckle.

How to replace a zipper?

Most people probably have a laptop now, but the zipper of the laptop bag needs to be opened and closed frequently, so I would like to share with you how to replace the zipper.

Prepare your tools, pliers and screwdriver.

Use a screwdriver to pry open the butt of the zipper, but don't use too much force, just make a hole big enough for the zipper to enter.

Put the pried open zipper head in from one side first. If the hole is not big enough, use a screwdriver to pry it bigger.

Put the zipper head in on one side, then try pulling it left and right.

Do the same with the other side of the zipper. If you find it difficult to put it in, you can press it with a screwdriver.

Move the zipper head to the starting position, and then use a screwdriver and pliers to tap the position where you just pried it on the left side.

Continue to use the screwdriver and pliers to tap the place where you just pried on the right side.

The zipper head can be replaced like this. If you feel it is difficult to pull in the middle, you can apply some candle on both sides.