How to clean the range hood fan wheel

In fact, there are many things in our lives that are difficult to clean. The most common one is the fan wheel in the range hood. Originally, the fan wheel in the range hood will absorb the fumes from cooking, and naturally it will be stained with a lot of oil. If this goes on for a long time, there will be a thick layer of oil on the fan wheel, and these oil stains cannot be completely cleaned by using hot water.

1. Take a plastic bottle (any beverage bottle that can be flattened by hand will do), use a sewing needle to poke more than 10 small holes on the lid, then add an appropriate amount of detergent, fill it with warm water and shake it evenly.

2. Start the range hood and use a plastic bottle filled with detergent to spray the cleaning liquid onto the area to be cleaned. At this time, you can see the oil and dirty water flowing into the oil storage bucket together, and pour it out as it is full.

3. After the cleaning solution in the bottle is used up, continue to prepare and repeat the cleaning. Continue until the dirty water becomes clear. Depending on the degree of dirt, it usually takes 3 rinses to clean it.

4. If there is a mesh cover on the fan blades, it is advisable to remove the mesh cover first to enhance the washing effect.

5. Use a rag to clean the area around the air inlet, the surface of the casing, the lampshade, etc.

6. Some old-style range hoods have too much grease deposits, so it is recommended that citizens find a professional electrical appliance cleaning company to clean them.

If it is a side-suction range hood that is easy to clean, it is best not to disassemble it, as it will have a great impact on the dynamic balance, noise, and range hood suction effect. If it is a direct suction range hood that does not require disassembly and cleaning, then you do not have to worry about the dynamic balance problem. You can remove the filter yourself. There is a plastic screw in the middle of the impeller. Remove it and then take out the impeller to clean it. After washing, just tighten the screws.

Side suction easy to clean range hoods need to be disassembled to affect performance balance, noise, and oil fume absorption efficiency. Direct suction range hoods that do not require disassembly and cleaning are used to worry about balance problems. Remove the plastic screws between the impeller and then take the impeller to clean it. After cleaning, tighten the screws.

Therefore, you should use some special methods. You can start the range hood first, and then pour the cleaning liquid you have prepared on the range hood. In this way, it can automatically clean the wind wheel inside the range hood during the rotation process, and then use a relatively dry towel to wipe the wind wheel. In this way, the cleaning effect can be achieved.