How to install a bathroom heater

As people's living standards continue to improve, people not only need objects that can provide convenience for their lives, they also need to improve quality. For example, when taking a shower, it is not a big deal in the summer, but especially in the cold winter, people will shiver as soon as they take off their clothes. However, a bathroom heater can help everyone solve this problem. The bathroom heater not only provides warmth in winter, but also provides warm lighting for everyone.

Nowadays, people have become more and more picky. In fact, the more picky people are, the more they can see inferior products at a glance. The fittest will survive, and slowly those products that people don't like will be abandoned. So it forces businesses to produce better products. But for a good bathroom heater, how should it be installed?

Part 1. Preparation

1. Open ventilation holes

Determine the location of the vents on the wall (it should be above the ceiling and slightly lower than the air outlet of the centrifugal fan housing of the appliance to prevent condensation in the ventilation pipe from flowing back into the appliance)

2. Install ventilation windows

Put one end of the ventilation pipe on the ventilation window, and fix the other end to the air outlet of the outer wall through the ventilation window along the outer edge of the wall. Fill the gap between the ventilation pipe and the ventilation hole with cement. Because the length of the ventilation pipe is 1.5M, when installing the ventilation pipe, it is necessary to consider that the distance from the center of the product installation position to the ventilation hole should not exceed 1.3M.

3. Determine the installation location of the bathroom heater

In order to achieve the best heating effect, the bathroom heater should be installed on the ceiling directly above the center of the bathtub or shower room. For suspended ceilings, please use materials with better strength and less resonance. After installation, the height of the bulb from the ground should be between 2.1-2.3M. Too high or too low will affect the use effect.

Part 2. Fixing the bathroom heater

1. Remove the Yuba mask

Unscrew all bulbs, disengage the spring from the ring of the mask and remove the mask. When disassembling and assembling the infrared heating bulb, keep your hands steady and avoid using excessive force.

2. Wiring

Connect one end of the interactive soft wire to the switch panel, and pull the other end out of the ceiling opening together with the power cord. Open the terminal cover on the box, connect the wires according to the wiring diagram and terminal markings, cover the terminal cover, and secure it with screws. Then tuck the excess wires into the ceiling so that the box can fit smoothly into the hole.

3. Connect the ventilation pipe

Pull out the end of the ventilation pipe extending into the room and put it on the air outlet of the centrifugal fan cover.

4. Push the box into the hole

Choose the correct direction according to the location of the air outlet and insert the heater box into the hole.

5. Fix the bathroom heater

Use 4 wood screws with a diameter of 4mm and a length of 20mm to fix the box to the ceiling wood block.

I don’t know if you have understood the installation of the bathroom heater after reading the above information. Now, if you want to master anything better, you need to understand its production principle and how to use it. So now everyone will ask why when they see something they don’t understand. In fact, this phenomenon is very good. It is easier to understand what are the shortcomings and slowly make improvements.