What should I do if my white watch strap is dirty?

Watches are a kind of jewelry that people love very much. Watches can help people understand time and arrange their daily processes. With the improvement of people's living standards, many people wear watches as decoration, and the number of expensive watches is increasing. In the process of using watches, people will inevitably get stains, which will affect the appearance of the watch. Therefore, it is also very important to clean the stains on the watch. Let's take a look at what to do if the white watch strap is dirty?

Method 1:

Preparation: an old magazine, a piece of clean plastic wrap, an old toothbrush, and detergent.

Operation process: First, stack the plastic wrap and magazine together, and then roll them into a cylinder. This will prevent the book from getting wet when cleaning the strap later. The watch is then worn on this rolled cylinder. Slowly expand the cylinder rolled up with magazines until the watch strap is fully stretched and the watch will not fall off. On the one hand, this is for the convenience of cleaning later, and more importantly, after stretching the strap, the stains in the gaps of the strap can be cleaned.

Now to clean the strap. It is better to clean the surface of the strap first, and then clean the stains in the gaps of the strap. These gaps are tightly connected, so it is difficult to clean the dirt inside. Now that these gaps have been stretched open by the cylinder made of books, the dirt inside can naturally be cleaned out. Then clean the back of the strap, also cleaning the surface stains first. Next, clean the stains in the crevices. Finally, clean the strap with clean water.

All the processes have been completed. All that remains is to place the strap in a cool place to dry. Be careful not to expose it to direct sunlight, as this will damage the quality of the strap.

Method 2:

Soak the watch strap in boiling water with detergent for about 15 minutes. Because the connection between the buckles on this kind of watch strap is very tight, the gap at the connection cannot be stretched open by rolling a book into a cylinder. Putting it in hot water utilizes the principle of thermal expansion and contraction, allowing the gaps at the joints to expand on their own, so that it can be cleaned. After 15 minutes, start cleaning the strap! Next, soak the strap in cold water for about 15 minutes. The purpose of this is, first, to wash away the detergent on the strap; second, also using the principle of thermal expansion and contraction, to restore the gaps in the strap to their original state. When the time is up, take out the watch strap and dry it in the shade.