How to repair a broken invisible zipper?

There are zippers everywhere in our life. Most of them are very obvious, such as zippers on suitcases, zippers on clothes, etc. These zippers are very obvious, but there are also many places where zippers are invisible. For example, most of the zippers on girls' skirts are invisible and cannot be seen by the naked eye. That is, the zipper is wrapped inside. If this kind of zipper is broken, it will be more difficult to repair, but it can still be repaired by the following methods.

How to repair a broken invisible zipper?

First, use pliers to pull off the top big tooth of the zipper, and pull both sides.

Then pull the zipper lock to the top and merge the teeth on both sides together.

Then put the zipper lock in (it is somewhat difficult because the diameter of the metal zipper is relatively thick. If it really cannot be put in, cut a small hole in the diameter. Remember, do not cut where the big teeth are installed, but cut near the top, otherwise the big teeth cannot be installed)

After the zipper lock is put in, install the big teeth and everything will be OK

If the chain is not opened and closed smoothly, if you pull the chain head hard, it will cause tooth engagement failure. At this time, apply paraffin or lubricating spray [Zipper Partner] to the surface and inside of the teeth, then move the slider several times and it will slide easily.

If you really don't know how to do it:

When opening and closing the zipper, sometimes the chain head bites the thread segment or fabric and the slider cannot be pulled. If you forcefully pull the slider, the bite will get deeper. You should push the slider back while untying the fabric. When it is fully bitten in, do not pull the slider with force, but slowly pull it back. Also, do not leave any hidden dangers when sewing the zipper.

The zipper pops open after being zipped

This problem is caused by the slider being pulled for too long and its diameter becoming larger. If you want to solve it temporarily, just use pliers to clamp the tail of the slider. Note that it is the tail, but be careful not to use too much force or clamp it off-center. If you want to solve it completely, you have to replace the slider. Most shoe repair shops will replace the zipper for just one or two dollars.

1. First, assemble the zipper

2. Both teeth are inserted into the buckle

3. Use a tool such as pliers to gently clamp the buckle twice

4. Apply vegetable oil or candle oil and pull it back and forth a few times

Note: Be sure to clamp it with pliers

How to fix a broken zipper:

1. First squeeze facial cleanser onto a wet towel and wipe the zipper back and forth. After wiping it several times, wash the wet towel and then wipe the zipper clean with the wet towel again.

2. Wipe the zipper dry with a dry towel and start waxing it by rubbing the zipper with a candle several times.

3. Pull the zipper back and forth and you will find that the zipper slowly becomes more flexible. Until you are satisfied, then use a dry towel to wipe off the remaining candle on the zipper.

4. To maintain it for a long time, it is recommended to apply a little oil after completing the above steps.