How to repair a broken sole in the middle

I find that everyone has such troubles in life. If something you like very much suddenly breaks, you will feel very distressed and will want all kinds of ways to repair it. In fact, it is the same with wearing shoes. After a period of time, many shoes will break in the middle of the sole due to various reasons. So how to repair a broken sole? The editor will introduce it to you below.

Most sports shoes have rubber soles, which are prone to breakage after aging.

How to prevent the rubber soles of sports shoes from aging:

1. Rubber-soled shoes need to be cleaned regularly. When the upper is dirty, wipe it gently with a soft cloth dipped in water.

2. If the sole is made of white rubber, it will be difficult to clean if it gets dirty. You need to use a small toothbrush dipped in detergent to gently brush it, and then wipe it with a dry cloth.

3. Maintain two or more pairs of interchangeable shoes and let the shoes take turns to rest.

4. When not wearing the shoes, take out the insoles and place them in a dry and ventilated place to allow the heat to dissipate and return to their original state.

5. When not in use for a long time, wash and dry it, wrap it with paper and store it in a dry place.

【Notes】

Do not scrub it hard with a brush and do not use bleach when cleaning.

Avoid water seepage, exposure to the sun and fire; avoid direct sunlight after washing, which may cause aging, deformation, fading and mesh breakage.

Avoid contact with sharp objects and chemicals. Try to avoid squeezing to keep the shoes in their original state without deformation.

Prepare shoe glue, rubber hammer, wire brush, scissors, discarded car tires, and rags

Use a rag to clean the broken part of the shoe. If the broken part is dirty, wash it with water and dry it before operation.

First put glue on the broken mark, close the broken mark, and then you can move to the next step after the glue dries.

Use scissors to cut a piece of tire rubber with a width of 3.5 cm. The length can be slightly shorter than the width of the disconnected part of the shoe. Use a wire brush to brush one side to make the surface frizzy, then brush the disconnected part of the shoe until it becomes frizzy.

Apply glue to the rough parts of the shoes and the rough parts of the tire respectively. After the glue has dried a little, stick them together and tighten them with a glue hammer to make them more secure.

After waiting for about half an hour, I can wear my shoes normally. I have saved another pair of shoes.